DB Heating

ENERGY MANAGEMENT - Continued


Saving Fuel - Boiler Sequencing


Some larger properties have more than one boiler doing the same job, this is usually because of extending the property and heating system or for convenience and lower cost when purchasing. Sometimes it is cheaper to buy 2 large domestic boilers than 1 commercial boiler, there are other advantages to this as well like reduced running cost's and maintenance and a spare if one breaks down.

photo

Warmworld have a cost effective control that promotes even wear and tear, reduces running costs and allows the system to achieve better results.

Why run 2 boilers for the domestic hot water when 1 will do, you will probably find 1 will do it more quickly as there will be less short cycling as the cylinder cannot take the full heating output anyway.

This can also be said for the heating once it is near its operating temperature, turning off one of the boilers automatically to reduce fuel burn.

The Warmworld boiler sequencer simply sits between the boilers and controls and monitors the requirement, turning on the boilers as and when required, swapping them over to promote even usage thus minimising maintenance costs and raising comfort levels within the building.

 

 

 

Controlling the Heat


Ordinary room thermostats (if you have one) don't always maintain an even temperature; this is basically because of the nature of the design and often cause large variations in temperature.

photo

For instance the thermostat may allow the temperature to rise above the required temperature by some 1-3 degrees before turning off the heating and the same below when turning back on.

Not only is this a waste of heat and fuel but it makes you feel uncomfortable as well, Dataterm accurately controls the heating to within 0.3°C by increments of 0.1°C saving you from hot and cold shifts in temperature and reducing your fuel usage.
Dataterm can further enhance the economic running of gas or oil condensing boilers allowing for a more balanced duty cycle and can keep the boiler in condensing mode for longer transferring more usually wasted heat in to useful heat.

< Prev
HOME ABOUT US PLUMBING HEATING TESTIMONIALS CONTACT US COMPLAINTS PROCEDURE
GAS CENTRAL HEATING OIL CENTRAL HEATING LPG CENTRAL HEATING BOILER SERVICING & MAINTENANCE
GROUND SOURCE HEAT PUMPS UNDERFLOOR HEATING SYSTEMS SOLAR HOT WATER BIOMASS SYSTEMS ENERGY MANAGEMENT FULLY FITTED BATHROOMS
© Copright 2017 | Created by i-createdesign